Indications
Pharmacology
Sodium Chloride nasal wash is a non-drug, isotonic saline solution that is used to moisturize nasal membranes. This formulation provides comfort for extensive and continuous use.
Sodium Chloride 0.9% nasal wash moistures inside the nose by dissolving and softening thick or crusty mucus thus helps to remove the mucus from the nose and makes breathing easier. Excess sodium is predominantly excreted by the kidneys with small amounts lost in faeces and sweat.
Dosage
Nasal Congestion: In infants, 1-2 drops of Sodium Chloride nasal wash in each nostril before feeds will help relieve congestion and allow more effective suckling.
Ear Wax Removal: Allow the Sodium Chloride nasal wash to warm to room temperature before use. It is important to put the drops into the ear carefully. Lie down on one side and fill the ear canal with the drops and wait for a few minutes before standing up. Age: from 6 months onwards. Put 3 to 4 drops into the affected ear(s) 3 to 4 times a day for 3 to 5 days.
Administration
How to use the Nasal Spray-
- Shake the bottle gently and remove the dust cover.
- Hold the spray with your forefinger and middle finger on either side of the nozzle and your thumb underneath the bottle. Press down until a fine spray appears. If using for the first time or if you have not used it for a week or more, press the nasal applicator several times until a fine moist comes out from the container.
- Gently blow the nose to clear the nostrils.
- Close one nostril and carefully insert the nasal applicator into the open nostril. Tilt your head forward slightly and keep the spray upright. Breathe in through your nose and while breathing in, press the white-collar of nasal applicator firmly down once to release a spray.
- Breathe out through your mouth.
- Repeat the above steps in the same/ other nostril for consecutive doses.
Cleaning: The nasal spray should be cleaned at least once a week. The procedures are as follows-
- Remove the dust cover.
- Gently pull off the nasal applicator.
- Wash the applicator and dust cover in warm water.
- Shake off the excess water and leave to dry in a normal place. Avoid to apply additional heat.
- Gently push the applicator back on the top of the bottle and re-fix the dust cover.
Reviews
There are no reviews yet.